Similarity Check

• We use  iThenticate similarity software for all submitted papers before the review process. It is clear that manuscripts whose originality are less than the standard of the journal will be rejected without being review.

 

Manuscript Preparation

• Submission of an article implies that the work described has not been published previously, that it is not under consideration for publication elsewhere, that its publication is approved by all authors and tacitly or explicitly by the responsible authorities where the work was carried out, and that, if accepted, it will not be published elsewhere in the same form, in English or in any other language, including electronically without the written consent of the copyright holder.

 

• The manuscript must be uploaded online considering the following instructions.

1- The PDF format of the paper must be uploaded.

2- The manuscripts edited in two columns will be REJECTED.

3- The language of the journal is English. 

4- Figures should be included in EPS format, done as professionally as possible.

 

• All submitted manuscripts must include the following items:

• • Title
  • List of authors, their affiliations and email addresses
  • Abstract
  • Keywords
  • Introduction
  • Main body
  • Results and discussion
  • Conclusions (optional)
  • Acknowledgments (optional)
  • References

 

Title

Make sure that the title is specific and concise. Titles should be presented in title case - all words except the first word should be in lower case letters.

 

List of authors, their affiliations and email addresses

Provide the full names and affiliations of all the authors. Affiliations should include department, university or organization, city, and country. One of the authors should be designated as the corresponding author, and their email address needs to be included.

 

Abstract

The abstract should briefly introduce the manuscript, not exceeding 400 words. No citations should be included in the abstract.

 

Keywords

At least 3 keywords or phrases should be included and must be separated by commas to distinguish them.

 

Introduction

State the objectives of the work and provide an adequate background, avoiding a detailed literature survey or a summary of the results.

 

Main body

The main body part should include the main proposed ideas, results and discussions.

 

Conclusions

A conclusion is where you summarize the paper's findings and generalize their importance, discuss ambiguous data, and recommend further research. An effective conclusion should provide closure for a paper, leaving the reader feeling satisfied that the concepts have been fully explained.

 

Acknowledgments

You as the author are free to decide whether to include acknowledgments or not. Usually, the acknowledgments section includes the names of people who in some way contributed to the work, but do not fit the criteria to be listed as the authors. This section of your manuscript can also include information about funding sources.

 

References

• The JHS uses the numbered citation method for reference formatting, with sequential numbering in the text, and respective ordering in a list at the end of the paper. An article should include vol., no., pages and year. 
• In the text, each reference number should be enclosed by square brackets. Citations of references may be given simply as “in [1] ...”, or as “in reference [1] ...”. Similarly, it is not necessary to mention the authors of a reference, unless the mention is relevant to the text. 
• Multiple citations within a single set of brackets should be separated by commas. Where there are three or more sequential citations, they should be given as a range [2, 7-9, 13].
• Only articles that have been published or are in press should be included in the references.

 

Final Accepted papers

• Upon acceptance of the paper, author(s) will be asked to submit the LaTeX source of their manuscript. Authors are encouraged to use the Journal of Hyperstructures LaTeX class file. The easiest way to prepare the article is to fill in this template.
• After the paper is accepted for publication, the withdrawal is not permitted in principle.

 

Open access

This journal is fully open access; all articles will be immediately and permanently free for everyone to read and download. Permitted reuse is defined by the following Creative Commons user license:

 

Creative Commons Attribution (CC BY): lets others distribute and copy the article, to create extracts, abstracts, and other revised versions, adaptations or derivative works of or from an article, to include in a collective work, to text or data mine the article, even for commercial purposes, as long as they credit the author(s), do not represent the author as endorsing their adaptation of the article, and do not modify the article in such a way as to damage the author's honor or reputation. Copyright for articles published in this journal is retained by the authors, with first publication rights granted to the Journal of Automation and Operation in Power Engineering. If the original authors and source are cited, No permission is required from the authors or the publishers for anyone to download, reuse, reprint, modify, distribute, and/or copy articles in this journal.

 

Copyright Transfer Form

An author submitting a paper should ensure that he or she has the right to publish the paper and that it contains nothing defamatory. The JHS will assume that all co-authors have agreed to the submission of any paper received. All authors should sign the journal copyright form on behalf of any and all co-authors and send it to the email address of JHS. The journal copyright form can be downloaded from here.

 

Conflict of Interest and Authorship Conformation Form

 All articles that are published in the journal must be accompanied by the form conflict of interest disclosure statement which can be downloaded from here .